Back  |  Next  |  Table of contents

Basic Contact  , Coil  |  Reversing ( a. / b. contact )  |  OR circuit  |  Symbol  |  Comment  |  Hard wire number

h Contact , Coil

h Contact   1. Click on the position.   2. Click on the [ a. contact ] or [ b. contact ].        * a. contact = Normally Open        * b. contact = Normally Closed   3. Click on the device name.   4. See the comment bar of software. h Coil   1. Click on the position.   2. Click on the device name.   3. See the comment bar of software.

* The symbol can be changed ( moved , copyed , deleted ) easily by the command button.

Command button   Comment bar

h Reversing ( a. / b. contact )

1. Click on the contact. 2. Click on the [ a. | b. ] button. 3. Click on the other side.

h OR circuit

h Set   1. Click on the top left corner. ( e.g.  01, 03 )   2. Click on the the [ Set ] button.   3. Click on the other side.  ( e.g.  02 , R 02 ) h Reset   1. Click on the top left corner. ( e.g.  01, 03 )   2. Click the [ Reset ] button.

h  [  Push  --|  ]  and  [  |--  Push  ] button

h [ Expand ] button

h [ Saparate ] button  (  e.g.  In case that contact [ 04 ] was clicked )

h Symbol

* Select the format which you are easy to understand.

Ladder Type 1 Type 2

h Format      h Setting   1. Click on the symbol.   2. Click on the [ Symbol ] button.   3. Select-click on the menu.

h Comment

h Device's comment   * Click on the bottom side of the symbol.   or  click on the [ Device's comment ] box. h Line comment   * Click on the right side of the bus bar.   or  click on the [ Line comment ] box.

h Hard wire number

Menu   1. Click on the menu. 2. See the comment bar of software.

Folder - 01